Stainlesssteel reaction kettle, the attention of the car is as follows:
1,before feeding the reactor（www.gfanyingfu.com） should be open to the agitator, without noise andnormal, will be added to the reactor, the number of feeding shall not exceedthe technical requirements.
2,before opening the steam valve, open the back valve, then open the intakevalve. Open the steam valve should be slow, so that the jacket preheating, stepby step, the pressure is not allowed to exceed the specified value.
3,the steam valve and the cooling valve can not be started at the same time, thesteam pipeline gas is not allowed to hammer and collision.
4,open the cooling water valve, the first open return valve, open the water inletvalve. Cooling water pressure shall not be less than 0.1 MPa, is not allowed tobe higher than 0.2 mpa.
5,water ring vacuum pump, to open the pump water, when the pump stops, the firststop after pump water, and should be excluded in water pump.
6,at any time to check the operation of the reactor, abnormal should be found inthe maintenance.
7,cleaning titanium epoxy (enamel) reactor, or the use of alkaline brush reactor,be careful not to damage the enamel.